Blasting Airplane With Lasers Makes It Harder For Ice to Stick

researchers from Fraunhofer Institute for Material and Beam Technology IWS, aircraft manufacturer Airbus, and the Dresden University of Technology in Germany have co-developed a better way to keep planes free of ice and snow. It uses a technology called Direct Laser Interference Patterning (DLIP), where a laser is split into multiple beams that overlap each other creating complex etched patterns on a surface where the beams are focused.

Illustration for article titled Blasting Airplanes With Lasers Makes It Much Harder For Ice to Stick to Wings
Photo: Fraunhofer Institute

By adapting the DLIP technique to create three-dimensional structures at the microscopic level, the laser etching technique is able to turn an airplane’s wing into a material with reduced surface area that ice simply has a hard time holding onto. As a result, after reaching a certain thickness and weight, built up ice simply falls off a wing all on its own. It could not only reduce the need for de-icing procedures at airports, but it could also remove the need for antifreeze and other chemical agents altogether.

Waiting for ice to spontaneously fall off on its own isn’t always an option, like when you’re cruising along at 500+ miles per hour, 30,000 feet in the air. So additional testing by the researchers found that while it took over a minute for ice to melt off a wing surface with 60 watts of heat applied, the same material, treated with the laser etching process, saw ice completely vanish after just five seconds with the same amount of heat. Not only does it mean an aircraft could be cleared of ice much faster without the use of chemicals, but it also means that aircraft manufacturers could include smaller heating systems that were just as effective, but with drastically reduced fuel consumption.

The new use for the DLIP technology isn’t only useful for keeping aircraft safe and free of ice, it could be applied to everything from the blades on giant power-generating windmills, to the hulls of ships braving icy waters. The biggest benefit could be applying it to the windows of a car, making scraping them clean on a cold winter’s morning as easy as wiping away raindrops—assuming, of course, that the etching process still lets you actually see through the glass.

Source: Blasting Airplane With Lasers Makes It Harder For Ice to Stick

Organisational Structures | Technology and Science | Military, IT and Lifestyle consultancy | Social, Broadcast & Cross Media | Flying aircraft